User's Manual

Battery Charger
42 DigiTrak
®
SE™ Operator’s Manual
Power Setup
Connect the AC power cord to the power unit, then plug the cord into an AC power receptacle (wall
outlet). Wait until the LED changes to orange before inserting a battery for charging.
Plug AC Power Cord into Power Unit
Charging a Battery Pack
With the battery charger connected to a power source and the LED illuminated orange, insert a battery
pack into the battery charger. The battery pack will be flush with the battery charger when it is properly
inserted. Do not attempt to charge a non-DCI battery pack or a DCI lithium-ion battery pack.
The LED will remain orange while the battery is initialized in the charger. When charging begins, the LED
will change to red. During the final stage of charging, the LED will change to green and then alternately
flash orange while the battery is topped-off. The battery is done charging when the LED becomes solid
green. It is recommended that the battery be removed from the charger within 24 hours.
After plugging in the charger or removing a battery, wait approximately 15 seconds before inserting
another battery pack. The battery charger is ready to charge a battery when the LED turns orange.
If the battery does not reach full charge within 4 hours, the charger will automatically go into trickle charge
mode to prevent overheating the battery.
LED Charger Mode
Orange Battery not connected.
Orange Battery initialization and analysis (approximately 30 seconds).
Red Fast charge (approximately 3 hours).
Green/Flashing Orange Top-off charge (approximately 15 minutes).
Green Battery is charged; trickle charge will occur until battery is removed
(recommended the battery be removed within 24 hours).
Red/Green Alternating Error. Contact DCI.
LED