User's Manual

Locating
52 DigiTrak
®
SE™ Operator’s Manual
3. Holding the receiver level, observe the position of the locating target ( ) relative to the receiver box
on the display. The figures below illustrate what you might see on the display and the actual position
of the receiver, transmitter, and locate points.
RLP
FLP
LL
Receiver Locate Mode Screen Actual Position of
Receiver and Transmitter
4. Walk in the direction indicated by the picture on the screen to center the target in the box.
5. When the target is centered in the box, hold the trigger in for one second or more so the receiver can
get a “lock” on the reference signal. The “R” symbol will appear at the top of the depth screen.
WARNING: Do not hold the trigger in unless you are precisely at the FLP (target centered in box). If
you are ahead of the FLP, you will set an incorrect reference that causes a ghost locate
line. In this case, you must reference again at the FLP.
RLP
FLP
LL
Receiver Depth Mode Screen Actual Position of
(at FLP with HAG on) Receiver and Transmitter
Locating
Target
Receiver
Box
Target-in-
the-box