User's Manual

54
20 WIDE TFT-LCD TV
Warning
Disconnect the power cable and signal cable connected to the product in
case of thunder or lightning.
Do not attempt to touch its power cord with wet hands.
If any electric pin is wet or dusty, remove the moisture or dust first before
use.
It is recommended to pull out the power cord unless you use it for a long
time.
Damaged power cord, plug or unfitted outlet may be very dangerous.
Do not install the set close to any heating sources.
Do not place heavy articles on it or step on the product.
The product should be installed on a clean and dry place.
When you detect any smog, unusual noise or smell, just disconnect the
electric power and refer servicing to qualified service personnel.
Do not place any bowl with water, beverage, can or other liquid products
on it.
Do not use or place any combustible sprayer or inflammable substances
close to the product.
Warning
Do not arrange the power cord close to any heating devices/sources.
Install the outdoor antenna for the set far away from high voltage cables.
When moving it, do not apply any forces on the set.
Do not attempt to disassemble, repair or change the product.
Whenever you need to repair, adjust or check it, refer servicing to qualified
service personnel.
Do not directly spray water or rub it with inflammable substances (thinner
or benzene) when cleaning it.
Do not wet or penetrate water over/into the set.
When cleaning the LCD surface, disconnect the power and use a piece of
smooth cloth against any scratches on it. Never use wet cloth.
Caution
Make sure to pull out the power cord when cleaning or removing the
product.
Ventilation should be always open and the set should be installed in a
well-ventilated and wide enough place (a minimum distance away from a
wall 10cm or more).
Do not install the set in a place directly exposed to sunlight.