User's Manual

ManualsBrandsDigital Data Communications Asia ManualsComputers & AccessoriesWireless USB Adapter

USB Wireless Adaptor User Manual

150Mbps USB Wireless Adaptor User Manual

一、Network Card Installation

Please follow the following steps to install your new wireless network card:

1. Insert the USB wireless network card into an empty USB2.0 port of your

computer when computer has power on. Never use force to insert the card, if

you feel it’s stuck, flip the card over and try again;

2. Insert device driver CD into the CDROM drive of your computer, double click

the ‘Setup.exe’ icon and run the ‘Setup.exe’ program;

3. Select ‘I accept the terms of the license agreement’, and then click ‘Next’;

4. Select the setup type that best suits your needs, ‘Install driver and Ralink

WLAN Utility’ are recommended;

Summary of content (8 pages)

PAGE 1
USB Wireless Adaptor User Manual 150Mbps USB Wireless Adaptor User Manual 一、Network Card Installation Please follow the following steps to install your new wireless network card: 1. Insert the USB wireless network card into an empty USB2.0 port of your computer when computer has power on. Never use force to insert the card, if you feel it’s stuck, flip the card over and try again; 2. Insert device driver CD into the CDROM drive of your computer, double click the ‘Setup.exe’ icon and run the ‘Setup.
PAGE 2
USB Wireless Adaptor User Manual 5. Click ‘Next’ , show the ‘Select Configuration Tool’ dialogue, you can manage this wireless adapter both by “Ralink Configuration Tool” and “Microsoft Zero Configuration Tool”; 6.
PAGE 3
USB Wireless Adaptor User Manual 7. Click ‘Install’, and the installation is in process; 8.
PAGE 4
USB Wireless Adaptor User Manual 4
PAGE 5
USB Wireless Adaptor User Manual 二、Connect to Wireless Access Point 1. After installation has finished, it will try to connect to any unencrypted wireless access point automatically. If you want to connect a specific wireless access point, or the access point you wish to connect uses encryption, you have to configure the wireless network card and input the correct password to get connected to the wireless access point. Double click to open desktop lower icon ; 2. Displays the following picture; 3.
PAGE 6
USB Wireless Adaptor User Manual 4. Choose the wireless access point’s SSID, and double-click it. If the AP is encrypted, you should follow the prompts to select the appropriate encryption type and enter a password; 5.
PAGE 7
USB Wireless Adaptor User Manual speed and so on. Click the icon ，then the and signal strength information.
PAGE 8
USB Wireless Adaptor User Manual FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.