User's Manual

14
BASIC OPERATION
5. Basic Operation
5.1.2) Manual Channel Memory at NTSC
Follow these steps for setting the Channel
Memory manually:
ྙ Select the channel by pressing the number
button(s).
ྚGPress the [TV MENU] button.
ྛSelect [Auto Fine Tune] by using the [¤/¦]
button.
 Select [Off] by using the [ඔ/ඖ] button.
ྜྷ Select [Fine Tune] by using the [/] button.
ྞ Press the [ඔ/ඖ] button for the tuning
adjustment.
ྟ Select [Channel] by using the [/] button.
ྠ Select [Add] or [Remove] by pressing the [ඔ/
ඖ] button.
ྡ Press the [Menu] button to exit the Channel
Memory setting.
If the [Auto Fine Tune] mode would be set [On],
[Fine Tune] mode should not be adjusted.
[Note] HRC and IRC are two special NTSC cable
standards in the US.
5.1 TV Channel Memory
5.1.1) Auto Channel Memory
Follow these steps for setting the Channel
Memory automatically:
ྙ Press the [TV MENU] button.
ྚ Select [Source] by using the [/] button.
ྛ Select TV signal input mode by pressing the
[ඔ/ඖ] button.
ྜ Select [Auto Memory] by using the [/]
button.
ྜྷ Press the [ඖ] button to start the channel
search.
If you want to stop auto memory, press the
[MENU] button. Only the channels searched up
to that time are memorized.
6(/
i
$'''(//$1*790(180(18
Tuning
Auto Memory
AAAA
Channel
Edit Labels
Auto Fine Tune
Fine Tune
Source
Region
Move
Add Remove
-12-
Select
Adjust
SEL
MENU
MENU
Cancel
MENU
Off On
Air
USA
i
Channel Searching...