Specifications

All other dwells in the program can be set in a similar

fashion by selecting “PD” followed by the relevant dwell

number.

Set the Number of Times to Repeat the Program

4. Scrolling through the main scroll until the param-

eter “PLC” is displayed and then depressing the

up or down button will reveal the present setting

of the loop count. This is the number of times

that the entered program will be repeated before

a continuous set point at the last level of the

program is achieved. By pushing the up or down

button the number of loops can be set at any

value from 1 to 999.

Set the Holdback Feature

5. Scroll through the main scroll list until “HB” is

displayed. Push the up or down button to reveal

the current value of holdback. The up or down

button can now be depressed to scroll to the

required value. Holdback is set in display units

and represents the allowable excursion of meas-

ured value away from the current set point, ei-

ther above or below, before the program is

forced into hold. The program will remain in hold

until the measured value comes within holdback

limits. This feature is active the whole time that

the program is running. When hold is forced

onto the program by holdback, the “HOLD’”leg-

end is not illuminated but either the “RAMP” or

“DWELL” legend will flash.

Implementing Programs

Program Execution

Once the program has been entered it can be set running

by depressing the ‘RUN/HOLD’ push button on the front.

With the run initiated, the program will commence and the

legend on the display will indicate if a ramp or dwell is

being performed. While a program is running the short

scroll will contain a third parameter “TIME.” Push scroll

MULTI-PROGRAMMABLE MODELS

Note

Be sure to select the program number

before pressing “Run/Hold.”