Service manual

8-30 DECcolorwriter 1000
8 FRU Disassembly/Assembly
Paper-pass sensor 2 and tray sensor
Paper-pass sensor 2 and the paper tray sense switches are located inside the paper-feed
module. You follow the same basic procedure to access either sensor.
1. Power down the printer and remove the power cord.
2. Remove the paper-feed module as explained in the previous procedure
“Paper-feed module” on page 8-5.
3. Remove the two screws securing the paper-feed circuit board to the
paper-feed module. (One screw is reached through an access hole.) Slide the
board out of the way.
Tools required
n #1 POSIDRIV® screwdriver
Figure 8-26 Removing the paper-feed circuit board
8699-24
Paper-feed
module
Paper-feed
circuit board
3