Technical data

6.3 Operator Call FIP
Table 6–3 (Cont.) Operator Call Messages
Number
Message Description and Action
Paper check errors when feeding from the paper tray.
3. Perform the following steps if the problem occurs when
feeding from the paper tray:
• Open the front door and inspect the condition of the
solenoid (SL501) that actuates the tray feed clutch.
Fix or replace any damaged FRU that you find.
• Inspect the 9-pin plug connecting to J209 on the
DC control board.
• Check the cables that run between J209 and the
front door.
• Swap the DC control board.
• Swap the front door unit.
11 PAPER OUT
1
The cassette is empty or no cassette is installed.
The paper out sensor and linkage detects an empty cassette.
Troubleshooting: Inspect and swap the following
components, in the order listed, to fix a paper out fault:
1. Inspect and swap the cassette.
2. Swap the feeder assembly or paper out sensor.
3. Swap the DC control board.
4. Swap the video control board.
1
This message is not displayed if the feeder option is not installed.
(continued on next page)
Control Panel Messages FIPs 6–5