Technical data

6.5 Service FIP
Table 6–5 (Cont.) Service Messages
Number
Message Description and Action
52 SERVICE The scanner motor is not up to speed. Check the scanner assembly
electrical connectors for good connections.
Troubleshooting: Perform the following steps:
1. Inspect the 6-pin J203 and J301 plugs connecting the DC control
board to the scanner assembly.
2. Swap the scanner assembly.
3. Swap the DC control board.
4. Swap the LVPSA.
SERVICE
53–59
Not used.
60 SERVICE
61 SERVICE
63 SERVICE
68 SERVICE
71 SERVICE
72 SERVICE
73 SERVICE
74 SERVICE
This range of numbers indicates a failure of an electronic on-board
component or the failure of a connection or communication pathway
between components. The errors are detected by the on-board CPUs.
See Section A.1, Extended Service Messages, for more information on
this range of error messages.
Troubleshooting: Swap the following components:
1. Video control board
2. DC control board
3. Interface board
70 SERVICE This is the expansion RAM memory error.
Troubleshooting: Swap the following components:
1. RAM expansion board
2. Video control board
3. DC control board
4. Interface board
(continued on next page)
Control Panel Messages FIPs 6–19