Technical data

Removal and Replacement Procedures

and RSL

This chapter contains the recommended spares list (RSL) and the removal and

replacement procedures for the ﬁeld replaceable units (FRUs) of the DEClaser

1100 series printer. To remove an FRU, you ﬁnd the procedure and then follow

the steps. To replace an FRU, you reverse the procedure, unless otherwise

noted.

The removal of most FRUs requires the removal of other components. For that

reason, a procedural step can refer you to another procedure. For example, to

remove the DC control board, you must perform the procedure to remove the

video control unit (VCU) and the upper and side covers. You should always

remove and replace the components in the order shown in the procedures.

Warning: Before you disassemble the DEClaser 1100 printer, make sure the

power switch is off and the ac line cord is disconnected from the rear of the

printer.

If you must operate a disassembled printer, power the printer on, do the

required task, then turn the power off, and pull the plug.

Use of controls or adjustment procedures other than those speciﬁed in this

manual may result in hazardous laser light exposure to yourself or to other

persons in the room. The safety information presented in Safety Warnings only

applies while the scanner cover is fully installed.

Before servicing the optical components, you must have attended the training

speciﬁed in Section D.1.

Removal and Replacement Procedures and RSL 10–1