Technical data

10.1 Rear Cover

Use the following procedure to remove and replace the rear cover from the

DEClaser 1100 printer:

1. Move the printer so the rear cover hangs over the edge of the table or desk.

2. Loosen the two captive screws that hold the top of the rear cover to the

bulkhead.

3. Open the rear cover.

4. Press down the two hinge tabs and pull the rear cover away from the

printer to disengage the rear cover hinges.

Caution: Handle the hinge clips gently. The hinge clips are made of soft

plastic that will easily cut or nick. When nicked, the hinge will not securely

engage.

5. Remove the cover.

006042s

10–2 Removal and Replacement Procedures and RSL