Technical data

10.16 Drive Assembly
10.16.1 Drum Drive Unit
Use the following procedure to remove and replace the drum drive unit gears:
Caution: Make sure you do not overtighten the screws that screw directly into
the plastic bulkhead.
1. Remove the following components:
a. EP-L cartridge, as shown in Section 10.13
b. Upper cover, as shown in Section 10.2
c. Right and left side covers, as shown in Section 10.3
d. Drive assembly, as shown in Section 10.16
2. Remove the three screws that hold the drum drive assembly to the plastic
bulkhead.
3. Remove the drum drive assembly.
006081s
Removal and Replacement Procedures and RSL 10–45