Technical data

10.19 DC Control Unit (DCU) or DC Control Board
Part 2, The DCU
Use the following procedure to remove and replace the DC control unit (DCU):
6. Perform part one of this procedure to disassemble the printer and to
disconnect the DC control board.
7. Remove the wires from the cable clamps.
8. Remove the LVPSA cable from the metal restraints .
9. Remove the two screws that hold the front of the DCU to the plastic
bulkhead.
10. Remove the two screws that hold the right side of the DCU to the side of
the baseplate of the printer.
11. Remove the DCU.
006091s
10–54 Removal and Replacement Procedures and RSL