Technical data

Caring For Your Server
D-3
Moving the Server
Perform the following steps before shipping or moving the server:
1. Back up all files stored on all hard disk drives.
2. Turn off the server.
3. Disconnect the power cord from the outlet and the back of the server.
4. Disconnect the other cables from the back of the server.
5. Insert a drive protection card in the 3½-inch diskette drive. If you do not
have a drive protection card, use a blank diskette.
6. Use two people to lift or move the server.
7. Package the server as described in the following section, "Packing the
Server."
Packing the Server
CAUTION:
Do not ship the server with an external
terminator installed. Having the terminator installed during
shipping might damage the cable connector.
If you are moving the server a short distance (from one room to another in the same
building), you do not have to pack the server. If you are shipping the server or
moving it by vehicle, pack the server to avoid damage.
Pack the server in the original packing material and containers. If you did not save
the boxes and packing material, use a sturdy carton and cushion the server well to
avoid damage.
Installing the Server at a New Location
After moving the server to a new location, follow the instructions in the
Installation
Guide
to unpack and install it.