Installation guide

Operating the RRD42 Compact Disc Drive
Inserting a
Compact Disc
To insert a compact disc into the RRD42 (Figure 5–5):
1. Gather both the compact disc caddy and the disc you wish to
insert.
2. If there is a protective film on the center of the caddy lid,
remove the film .
3. Open the caddy by pressing the tabs on both sides of the
caddy at the end opposite the shutter .
4. Set the disc, printed side up, into the caddy as shown .
5. Press firmly on both corners to close the caddy lid.
6. Insert the disc caddy into the drive . Push the caddy
gently into the drive as far as it will go. The caddy should be
completely inside the drive when properly inserted.
The busy light comes on when the caddy has been inserted
correctly.
7. When the busy light goes off, the compact disc drive is
ready to use. To operate the compact disc drive, follow the
instructions provided with your system software.
Removing a
Compact Disc
To remove a compact disc (Figure 5–5):
1. Press the eject button .
The caddy will automatically eject part way.
2. Remove the caddy from the drive .
RRD42 Light
The RRD42 busy light comes on when the system is reading data
from the compact disc.
5–14 Operating Mass Storage Devices