Installation guide

Operating the TLZ06 Tape Drive
Inserting a Tape
into the TLZ06
To insert the DDS tape into the TLZ06 (Figure 5–7):
1. Check to see that the tape/activity light on the drive is unlit.
If it is lit, there is already a tape in the drive. Remove the
tape from the drive before continuing. (See Removing a Tape
from the TLZ06, below).
2. Set the write-protect switch on the DDS tape that you wish
to insert to either the write-protected or write-enabled
position.
3. Insert the DDS tape into the drive, with the tape oriented as
shown in .
Removing a
Tape from the
TLZ06
To remove a DDS tape from the TLZ06 (Figure 5–7):
1. Check to see that the tape/activity light is on solid green. If
the tape/activity light is flashing, the drive has not finished
completing a data transfer. Wait until the tape/activity light
comes on solid green before proceeding.
2. Press the unload button to eject the tape .
The tape ejects part way.
3. Remove the tape from the drive .
5–18 Operating Mass Storage Devices