Technical data

Installation
Step
Eight: Turn on the Power to the InfoTower cabinet.
Step Eight: Turn on the Power to the InfoTower Cabinet.
'fum the power on to the cabinet. The power switch is located near the fan
at the rear of the cabinet. Tum the power on to any attached external SCSI
devices.
Step Nine: Turn on the Power to the InfoServer System.
'fum on the power to the InfoServer system. Example 2-1 shows the
InfoServer .system
console displays. When booting is complete, a password
prompt
will appear on the console. Refer to Chapter 4 if the system fails to
boot.
Example 2-1 Display for InfoServer System
KA41-2 Vl.O
F •. E •.• D ••. C •.. B .•• A ..• 9 .. 8 ••. 7 ... 6 ... 5 •.. 4_ •• 3_ .• 2_ .. 1. ..
?-E 0040 0000.0005 -
? C 0080 0000.4001
83 BOOT SIS
-DKAlOO
DEC InfoServer 150
Copyright (c) 1991 Digital Equipment Corporation
%ESS-I-INITDisc, Disc Initialization complete, 14 devices found
Step Ten: Verify Drive Access.
At the InfOServer system console, enter the SHOW DEVICE command to
ensure that all of the connected drives are accessible by the InfoServer system.
Example
2-2 shows the SHOW DEVICE command display.
Installation 2-15