Technical data

3
Adding Additional SCSI Drives
This chapter describes how to add additional drives to the InfoServer system
and InfoTower cabinet. (The H056-drive mounting bracket option is purchased
separately.)
_______________________ Note ______________________ _
The power supply used in the InfoTower requires a minimum load 'of
3A on the +5V source for proper regulation. Ensure that the devices
installed
in the cabinet present a load to satisfy this requirement. ,',
Configuring Drives
When configuring a drive, refer to the configuration information provided
with the drive. SCSI device addresses are generally set in accordance with
Table 3-1. Always tum the power off before installing the drive. Always check
to see which device addresses are in use before adding devices.
Table 3-1
Drive Switch/Jumper Settings
Device
Address
0
1
2
1 =On/In
0= Oft7Out
101
102
0 0
1
0
0 1
103
0
0
0
(continued on next page)
Adding Additional SCSI Drives 3-1