User`s guide

2.3 Removing the SW300 Enclosure from the Pallet
Use the following procedure to remove the SW300 enclosure from the shipping
pallet:
WARNING
Serious personnel injury may result if correct safety precautions are not
taken during the removal procedure.
1. Attach the ramp by fitting the ramp lip into the groove on the pallet, as
shown in Figure 2–3.
Figure 2–3 Shipping Pallet Ramp Installation
CXO-4318A-MC
FRONT
CASTERS
2. Lift the lock lever on each front caster to the up position so the SW300
enclosure can be moved.
WARNING
Three people are recommended to unload the SW300 from the shipping
pallet. Failure to use sufficient personnel may result in personnel injury
and equipment damage.
CAUTION
Do not drop the SW300 from a height greater than two inches or serious
structural damage can result.
3. Grasping the sheet metal base assembly, carefully lift the rear of the SW300
enclosure over the ‘‘hump’’ in the middle of the pallet and roll the SW300
enclosure off the pallet and down the ramp to the floor. If any further lifting
Unpacking and Installation Instructions 2–3