User`s guide

Figure 3–1 SW300 SCSI Buses
id 3
id 6
id 2
id 1
id 0
id 7
id 3
id 6
id 2
id 1
id 0
id 7
id 3
id 6
id 2
id 1
id 0
id 7
id 3
id 6
id 2
id 1
id 0
id 7
id 3
id 6
id 2
id 1
id 0
id 7
id 3
id 6
id 2
id 1
id 0
id 7
SHELF 4
SHELF 3
SHELF 2
SHELF 1
CONTROLLER
SLOT 6
CONTROLLER
SLOT 7
CXO-4315A-MC
PORT 1 PORT 2 PORT 3 PORT 4 PORT 5 PORT 6
3.5 Recommended Loading Sequence
The recommended loading sequence for the SW300 enclosure is as follows:
1. Install a controller in slot 7.
2. Install a controller in slot 6.
3. Install storage device SBBs left to right, bottom to top. Therefore, the first
storage device SBB should be installed in port 1, ID 0, on shelf 1, as shown in
Figure 1–8. The second storage device SBB should be installed in port 2, ID
0, in Shelf 1, and so on with the last SBB installed in port 6, ID 3, in shelf 4.
3.6 HS Array Controller Configurations
For information on redundant array of independent disks (RAID) and other
controller configurations, see the StorageWorks Array Controllers HS Family of
Array Controllers User’s Guide.
Configuration Rules and Restrictions 3–3