Manualshelf

User`s guide

ManualsBrandsDigital Equipment Corporation ManualsHome building and DecorStorage Works
12345678910
4.6 Power Supply SBB LEDs and Fault Notification . . . . . . . . . . . . . . . . . . . . 4–7
4.7 Dual Speed Blower Fault Notification . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–8
5 Removal and Installation Procedures
5.1 Removing a Power Supply SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5–1
5.2 Installing a Power Supply SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5–2
5.3 SBB Warm Swap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5–2
5.4 Removing a Storage Device SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5–3
5.5 Installing a Storage Device SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5–5
5.6 Removing an Environmental Monitor Unit . . . . . . . . . . . . . . . . . . . . . . . . 5–6
5.7 Installing an Environmental Monitor Unit . . . . . . . . . . . . . . . . . . . . . . . . 5–6
5.8 Removing a Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5–6
5.9 Installing a Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5–7
5.10 Removing a Dual Speed Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5–7
5.11 Installing a Dual Speed Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5–8
5.12 Removing an AC Power Entry Controller . . . . . . . . . . . . . . . . . . . . . . . . . 5–9
5.13 Installing an AC Power Entry Controller . . . . . . . . . . . . . . . . . . . . . . . . . . 5–9
Glossary
Index
Figures
1–1 SW300-Series Deskside RAID Enclosure . . . . . . . . . . . . . . . . . . . . . . 1–2
1–2 SW300 Components (Cabinet Removed for Clarity) . . . . . . . . . . . . . . . 1–4
1–3 SW300 Power Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–5
1–4 Dual Speed Blowers (Cabinet Removed for Clarity) . . . . . . . . . . . . . . . 1–9
1–5 3½-Inch Power Supply SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–10
1–6 3½-Inch SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–11
1–7 5¼-Inch SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–12
1–8 SW300 SCSI Buses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–13
2–1 Minimum Installation Clearance Measurements . . . . . . . . . . . . . . . . . 2–1
2–2 Unpacking the SW300 Enclosure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2–2
2–3 Shipping Pallet Ramp Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2–3
3–1 SW300 SCSI Buses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3–3
4–1 SW300 Light Emitting Diodes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–2
4–2 EMU Control Panel LEDs and Switches . . . . . . . . . . . . . . . . . . . . . . . 4–3
4–3 HS Controller Operator Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . 4–5
4–4 3½-Inch Storage SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–7
4–5 5¼-Inch SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–7
4–6 3½-Inch Power Supply SBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–8
5–1 Removing a Power Supply SBB (Cabinet Removed for Clarity) . . . . . . 5–2
5–2 Removing a Storage Device SBB (Cabinet Removed for Clarity) . . . . . 5–4
5–3 Removing a Dual Speed Blower (Cabinet Removed for Clarity) . . . . . . 5–8
iv