User`s guide

Preface
Intended Audience
This manual is intended for use by customer and Digital™ employees responsible
for installing, configuring, operating, and maintaining the SW300-series
redundant array of independent disks (RAID) enclosure. Replacing the ac
power entry controller must be performed only by qualified service personnel.
Structure
This manual is organized as follows:
Chapter 1 Describes the SW300 enclosure including physical characteristics,
layout, specifications, components, and StorageWorks products.
Chapter 2 Describes site preparation, unpacking, installation, and powering up
procedures for the SW300 enclosure.
Chapter 3 Describes the rules and restrictions for configuring an SW300
enclosure.
Chapter 4 Describes the error analysis and fault isolation of the SW300
components.
Chapter 5 Describes the procedures for removing and installing the ac power
entry controllers, power supply and storage device StorageWorks
building blocks (SBBs), environmental monitor units (EMUs),
controllers, and dual speed blowers.
Glossary Defines SW300 terms.
Related Documents
The following table lists documents (alphabetically by title) that contain
information related to this product.
Document Title Order Number
StorageWorks Array Controllers HS Family of Array Controllers Service Manual EK–HSFAM–SV
StorageWorks Array Controllers HS Family of Array Controllers User’s Guide EK–HSFAM–UG
StorageWorks Solutions Configuration Guide EK–BA350–CG
StorageWorks Solutions High-Availability Storage Subsystem Fault Bus OEM
Engineering Specification
EK–FAULT–ES
StorageWorks Solutions Shelf and SBB User’s Guide EK–BA350–UG
StorageWorks Solutions 3½-Inch Device Installation Guide EK–MC350–IG
StorageWorks Solutions 5¼-Inch Storage Device Installation Guide EK–MC525–IG
StorageWorks SW800-Series Data Center Cabinet Installation and User’s Guide EK–SW800–IG
vii