User`s guide

For HSD30 array controllers—You should have connected the appropriate

host port cables and/or terminators to the supplied trilink connector on the

front bezel of your controller BEFORE you applied power. Figure 4–6 shows

the trilink connectors, DSSI host port cable, DSSI host port cable jumper, and

terminator for a dual-redundant HSD30 array controller conﬁguration. See

Section 4.6.2.2 for detailed instructions for installing these components.

CAUTION

If your HSD30 array controller’s host port connector does not have

a mating guide installed as shown in Figure 4–2, do not connect or

disconnect the host port cables with power applied.

Figure 4–6 DSSI Host Port Cable Connection

CXO-4206A-MC

HSD30

TRILINK

CONNECTOR

TERMINATOR

DSSI HOST

CABLE

4–16 Installation