User`s guide

When the new controller and cache modules are installed, set your initial

conﬁguration parameters for the new controller using the procedure in

Section 5.2.5. Do not install your host port cables until the initial parameters are

set.

4.8 Installing the Program Card

This section describes how to insert or remove the program card. Figure 4–12

shows the location of the program card and its associated eject button. An

ESD shield is shown over the program card on the controller in the righthand

controller position.

Insert the program cards prior to applying power to your subsystem cabinet by

doing the following (the program cards may already be installed):

1. Attach an ESD grounding strap to your wrist at one end and to a cabinet

grounding stud at the other end.

2. Remove the program card ESD shield by pulling the two plastic push/pull

pins on each side of the shield.

3. Press and hold the reset (//) button while inserting the card into the program

card slot on the controller’s front bezel until the eject button is even with the

edge of the card.

4. Snap the program card ESD shield in place over the program card by pressing

the plastic push pins in on each side of the shield.

5. Remove the ESD grounding strap.

CAUTION

The program card must remain inserted at all times during controller

operation with the ESD shield in place. If the program card is removed

during operation, the controller will not function and the reset button

must be used.

Installation 4–27