User`s guide

ManualsBrandsDigital Equipment Corporation ManualsHome building and DecorStorage Works

121

122

123

124

125

126

127

128

129

130

exercisers. There are additional commands used to run local programs such

as, CFMENU, FLS, and so forth.

Remember these two rules when using the CLI:

• Not all conﬁguration parameters need to be speciﬁed on one line. They can be

entered by using multiple SET commands.

• Only enough of each command needs to be entered to make the command

unique (usually three characters). For example, SHO is equivalent to SHOW.

5.2.3 How to Exit CLI

If you are using a maintenance terminal, you cannot exit the CLI. Entering the

EXIT command merely restarts the CLI and redisplays the controller type, and

the last fail error information as shown in Example 5–1:

Example 5–1 CLI EXIT Command Message

CLI> EXIT

HSJ40 Firmware version V25J, Hardware version 0000

Last fail code: 018800A0

Press " ?" at any time for help.

CLI>

If you are using a DUP connection for the CLI, type EXIT after the CLI prompt

to return control to the host.

If you are connected to a virtual terminal via DUP for OpenVMS, and you

speciﬁed the /LOG qualiﬁer on your command line, a log ﬁle of your session in

CLI is created. You must use the EXIT command to exit the CLI in order to print

the log ﬁle.

5.2.4 Setting Conﬁguration Parameters for a Nonredundant Controller

Conﬁguration

If you have a nonredundant controller conﬁguration, perform the following steps

at initial installation (or when replacing a failed controller module) to set up your

controller’s conﬁguration parameters from the CLI.

Deﬁne the conﬁguration in the following order from a maintenance terminal

connected to the terminal port connector on the front bezel of your controller.

Not all steps are applicable to each controller model. Therefore, each step in the

following procedure lists applicable models for that step.

CAUTION

Do not install the host port cables for your new controller until after you

have set all of the initial parameters. Failure to follow this process may

result in adverse effects on the host/cluster. Follow the speciﬁc rules for

your controller model regarding the application of power when installing

host cables.

5–6 Controller Operations