User`s guide

Table 5–4 (Cont.) Controller Module Replacement
Step Description
13 Snap the program card ESD shield into place by pressing the two plastic push
pins on each side of the shield.
14 Remove the ESD grounding strap from the cabinet and your wrist.
15 Enter the SET FAILOVER COPY=OTHER_CONTROLLER command to copy
the configuration information from the good (other) controller to this new
controller.
16 Enter the SHOW THIS_CONTROLLER FULL to ensure that the dual-
redundant configuration has been created. Enter the SHOW UNITS, SHOW
DEVICES, and SHOW STORAGESETS as applicable.
17 Close and lock the cabinet door.
Figure 5–9 OCP Cable, HSJ Array Controller
OCP RIBBON
CABLE
CONNECTION
CXO-4119A-MC
Controller Operations 5–41