User`s guide

Example 7–2 (Cont.) Using All Defaults (Read-Only)
DILX Summary at 13-JAN-1994 04:49:14
Test minutes remaining: 9, expired: 1
Unit 10 Total IO Requests 4530
No errors detected
Unit 12 Total IO Requests 2930
No errors detected
Reuse Parameters (stop, continue, restart, change_unit) [stop] ?
DILX - Normal Termination
HSJ>
7.3.2.3 Using Auto-Configure with Half of the All Units Option
In Example 7–3, DILX is run using the Auto-Configure option with the half of all
units option:
Example 7–3 Using Auto-Configure with Half of the All Units Option
HSJ> RUN DILX
Disk Inline Exerciser - version 2.0
The Auto-Configure option will automatically select, for testing, half or
all of the disk units configured. It will perform a very thorough test with
*WRITES* enabled. The user will only be able to select the run time and
performance summary options and whether to test a half or full configuration.
The user will not be able to specify specific units to test.
The Auto-Configure option is only recommended for initial installations.
Do you wish to perform an Auto-Configure (y/n) [n] ?y
If you want to test a dual redundant subsystem, it is recommended that
you pick option 2 on the first controller and then option 2 on the
other controller. Auto-Configure options are:
1. Configure all disk units for testing. This is recommended for a
single controller subsystem.
2. Configure half of all disk units for testing, this is recommended
for a dual controller subsystem.
3. Exit Auto-Configure and DILX.
Enter Auto-Configure option (1:3) [3] ?2
**** C a u t i o n ****
All data on the Auto-Configured disks will be destroyed.
You *MUST* be sure of yourself.
Are you sure you want to continue (y/n) [n] ?y
Enter execution time limit in minutes (1:65535) [60] ?
Enter performance summary interval in minutes (1:65535) [60] ?
Unit 12 successfully allocated for testing
Unit 21 successfully allocated for testing
Unit 61 successfully allocated for testing
(continued on next page)
7–10 Diagnostics and Utilities