User`s guide

Example 7–3 (Cont.) Using Auto-Configure with Half of the All Units Option
DILX testing started at: 13-JAN-1994 04:39:20
Test will run for 60 minutes
Type ^T(if running DILX through VCS) or ^G(in all other cases)
to get a current performance summary
Type ^C to terminate the DILX test prematurely
Type ^Y to terminate DILX prematurely
DILX Summary at 13-JAN-1994 04:41:39
Test minutes remaining: 58, expired: 2
Unit 12 Total IO Requests 8047
No errors detected
Unit 21 Total IO Requests 15239
No errors detected
Unit 61 Total IO Requests 19270
No errors detected
Reuse Parameters (stop, continue, restart, change_unit) [stop] ?
DILX - Normal Termination
HSJ>
7.3.2.4 Using Auto-Configure with the All Units Option
In Example 7–4, DILX is run using the Auto-Configure option with the all units
option:
Example 7–4 Using Auto-Configure with the All Units Option
HSJ> RUN DILX
Disk Inline Exerciser - version 2.0
The Auto-Configure option will automatically select, for testing, half or
all of the disk units configured. It will perform a very thorough test with
*WRITES* enabled. The user will only be able to select the run time and
performance summary options and whether to test a half or full configuration.
The user will not be able to specify specific units to test.
The Auto-Configure option is only recommended for initial installations.
Do you wish to perform an Auto-Configure (y/n) [n] ?y
If you want to test a dual redundant subsystem, it is recommended that
you pick option 2 on the first controller and then option 2 on the
other controller. Auto-Configure options are:
1. Configure all disk units for testing. This is recommended for a
single controller subsystem.
2. Configure half of all disk units for testing, this is recommended
for a dual controller subsystem.
3. Exit Auto-Configure and DILX.
Enter Auto-Configure option (1:3) [3] ?1
**** C a u t i o n ****
All data on the Auto-Configured disks will be destroyed.
You *MUST* be sure of yourself.
(continued on next page)
Diagnostics and Utilities 7–11