User`s guide

Waiting for completion of CLI command...
Explanation: Some CLI commands take a long time to complete, such as
initializing a large RAIDset or adding a tape drive that needs to have the
tape rewound. CFMENU prints out this message periodically to inform you
that it is still waiting for the last CLI command to finish.
7.3.10.13 Exiting CFMENU
Enter the last option from the main menu to stop CFMENU and return to the
CLI. (You also may enter Ctrl/C or Ctrl/Y to abort CFMENU.)
7.3.11 Code Load/Code Patch (CLCP) Utility
The Code Load/Code Patch utility allows you to perform two memory modification
functions in the controller:
• Code loading—You can upgrade the firmware in your controller’s PCMCIA
card via the MMJ maintenance port (HSZ40–Bx only).
Note
The code load portion of the CLCP utility is only supported on HSZ40–Bx
array controllers with HSOF firmware Version 2.1 or greater.
• Code patching—You can alter memory locations in the controller’s RAM while
the controller is active.
7.3.11.1 Invoking the CLCP Utility
The CLCP utility is invoked using the RUN command via the CLI interface as
follows:
CLI> RUN CLCP
Select an option from the following list:
Code Load & Code Patch local program Main Menu
0: Exit
1: Enter Code LOAD local program
2: Enter Code PATCH local program
Enter option number (0..2) [0] ?
You select the desired option number and the appropriate option of the utility
executes, prompting for further inputs.
CAUTION
The write protect switch on the program card is shipped from the factory
in the write protect position. Before loading or patching the program
card, slide the write protect switch on the bottom right-hand end (when
the label is facing up) of the card (this can be done with the card still
inserted in its slot) to the left. This action shuts off the write protection
and allows you to write the new information. When the card has been
rewritten, remember to slide the switch back to the right (the write
protect position).
Diagnostics and Utilities 7–71