User`s guide

0: Exit
1: Enter a Patch
2: Delete Patches
3: List Patches
Enter option number (0..3) [0] ?
Attempting to Enter a Patch Number That Already Exists
The following is an example of what happens when you enter a patch number
that is already loaded for the specified firmware version:
CLI> RUN CLCP
Select an option from the following list:
Code Load & Code Patch local program Main Menu
0: Exit
1: Enter Code LOAD local program
2: Enter Code PATCH local program
Enter option number (0..2) [0] ? 2
----------------------------------------------------------------------
You have selected the Code Patch local program. This program is
used to manage firmware code patches. Select an option from the
following list:
Type ^Y or ^C (then RETURN) at any time to abort Code Patch.
Code Patch Main Menu
0: Exit
1: Enter a Patch
2: Delete Patches
3: List Patches
Enter option number (0..3) [0] ? 1
This is the Enter a Patch option. The program prompts you
for the patch information, one line at time. Be careful
to enter the information exactly as it appears on the patch
release. Patches may be installed for any version of firmware;
however, patches entered for firmware versions other than XLZ6
are not applied until the matching version of firmware is
installed.
To enter any patch, you must first install all patches with
lower patch numbers than the patch you are entering, beginning
with patch number 1, for the specific firmware version.
If you incorrectly enter the patch information, you are given the
option to review the patch one line at a time.
Type ^Y or ^C (then RETURN) at any time to abort Code Patch.
Do you wish to continue (y/n) [y] ? Y
Version: ? xlz6
Length: ? 10
Patch Type: ? 0
Patch Number: ? 2
The patch you entered is already installed on this controller.
If you wish to reinstall patch number 2 for firmware version XLZ6 ,
use the Delete Patches option from the Code Patch Main Menu.
Code Patch Main Menu
0: Exit
1: Enter a Patch
2: Delete Patches
3: List Patches
7–80 Diagnostics and Utilities