User`s guide

Example 8–3 (Cont.) DECevent Bit-to-Text Translation Error Event Report
MSCP Unique Controller-ID x0000000940802576
MSCP Controller Model 40. HSJ40 HS Array Controller
MSCP Controller Class 1. Mass Storage Controller class
Controller SW version 20.
Controller HW version 73.
MSCP Unique Unit-ID x0000000000000022
MSCP Unit Model -1. HSX0n MSCP basic/virtual disk
MSCP Unit Class 2. Disk class - DEC Std 166 disk
Unit SW version 1.
Unit HW version 67.
MSCP Event Code x014B Major Event = Drive Error
Sub-event = Controller Detected Protocol
Error
Multiunit code x0035
Error recovery Level 1.
Retry count 0.
Volume Serial Number 0.
Header code x00000000 Flags= Good LBN
LBN = 0.
------- HSAC Data -------
Instance Code x030C4002 A Drive failed because a Test Unit Ready
command or a Read Capacity command failed.
Component ID = Device Services.
Event Number = x0000000C
Repair Action = x00000040
NR Threshold = x00000002
Template Type x51 Disk Transfer Error.
Power On Time Value x00000000000B9331
Completed Byte Count 0.
Starting LBN 0.
Device Locator x00000504 Port = 4.
Target = 5.
LUN = 0.
SCSI Device Type x1F Device Type not decoded.
Drive Product Name RZ26 (C) DEC
Drive Serial Number 35349717
Command Opcode x00 Test Unit Ready
Sense Data Qualifier x00 Buf Mode = The target shall not report
GOOD status on write commands
until the data blocks are
actually written on the
medium.
UWEUO = zero, not defined
MSBD = zero, not defined
FBW = zero, not defined
DSSD = Sense Data fields were generated
by the HSAC controller on behalf
of the target devices because the
Sense Data could not be obtained
from that device.
(continued on next page)
Operating System Support 8–15