User`s guide

ADD LOADER
ADD LOADER
Note
This command is valid for HSJ and HSD controllers only.
Adds a loader to the list of known loaders.
Format
ADD LOADER container-name SCSI-location
Parameters
container-name
Specifies the name that is used to refer to this loader. The name must start with
a letter (A–Z) and can then consist of up to eight more characters made up of
letters A–Z, numbers 0–9, periods (.), dashes (-), or underscores (_), for a total of
nine characters.
SCSI-location
The location of the loader to be added in the form PTL where P designates the
port (1–6 or 1–3, depending on the controller model), T designates the target ID
of the device, (0–6, in a nonfailover configuration, or 0–5 if the controller is in a
failover configuration), and L designates the LUN of the device (must be 0).
When entering the PTL, at least one space must separate the the port, target,
and LUN numbers.
Description
Adds a loader to the list of known loaders and names the loader. This command
must be used when a new SCSI–2 loader is to be added to the configuration.
Examples
1.
CLI> ADD LOADER LOAD0 2 0 0
Adds a loader to port 2, target 0, LUN 0 and names it LOAD0.
Command Line Interpreter B–5