Manualshelf

User`s guide

ManualsBrandsDigital Equipment Corporation ManualsHome building and DecorStorage Works
411412413414415416417418419420
SET NOFAILOVER
SET NOFAILOVER
Removes THIS_CONTROLLER and OTHER_CONTROLLER (if reachable) from
a dual-redundant configuration.
Format
SET NOFAILOVER
Description
The SET NOFAILOVER command removes THIS_CONTROLLER and the
OTHER_CONTROLLER (if currently reachable) from a dual-redundant
configuration. Before or immediately after entering this command, one controller
should be physically removed because the sharing of devices is not supported by
single controller configurations.
The controller on which the command was entered is always removed from a
dual-redundant state, even if the other controller is not currently reachable. No
configuration information is lost when leaving a dual-redundant state.
Note
When the SET NOFAILOVER command is issued, the other controller is
shutdown (with dual-redundant configurations that have two surviving
controllers).
Examples
1.
CLI> SET NOFAILOVER
Removes the two controllers from a dual-redundant configuration.
Command Line Interpreter B–65