User`s guide

Error 2030: This port, target LUN combination already in use by another device
Explanation: When adding a device, you specified PTL that is already
specified by another device.
Error 2040: Cannot set TRANSPORTABLE when device in use by an upper layer
Explanation: A disk cannot be set to TRANSPORTABLE when it is being
used by an upper level (unit or storageset).
Error 2050: Cannot set NOTRANSPORTABLE when device in use by an upper
layer
Explanation: A disk cannot be set to NOTRANSPORTABLE when it is
being used by an upper level (unit or storageset).
Error 2060: Can only clear UNKNOWN errors on a device
Explanation: You attempted to clear UNKNOWN on a storageset or a unit.
Check the name of the device and reissue the command.
Error 3000: Cannot INITIALIZE a PASSTHROUGH device
Explanation: You cannot initialize a passthrough device.
Error 3020: Cannot add <disk name>; This will cause too many members
in MIRRORSET <mirrorset name>. Use a SET <mirrorset name>
MEMBERSHIP=<new count> to command increase the membership count
first
Explanation: You can not add more disks to a mirrorset than is specified
by the mirrorset’s membership count. In order to successfully do a SET
<mirrorset name> REPLACE=<disk name>, to a ‘‘full’’ mirrorset, you must
first increase the mirrorset count.
Error 3030: <disk name> is not a member of <mirrorset name>, cannot be used
for the read source
Explanation: When specifying a specific disk as a read source for a
mirrorset, the disk specified must be a member of the mirrorset.
Choose a disk that’s a member of the mirrorset and retry the command.
Error 3040: Cannot set read source to a specific device if mirrorset not configured
as a unit
Explanation: Setting a mirrorset’s read source to a specific device cannot be
accomplished if the mirrorset is not configured as a unit.
Create a unit from the mirrorset and try the command again.
Error 3050: <disk name> could not be initialized as a spare disk
Explanation: When adding spare disks to the spareset, they are initialized
with special spare disk metadata. If the metadata cannot be written, error
3050 results.
Error 3060: <disk name> is not a member of the spareset
Explanation: You attempted to delete a disk drive from the spareset that
was not a member of the spareset.
B–132 Command Line Interpreter