User`s guide

Error 3260: <disk name> is a TRANSPORTABLE disk. TRANSPORTABLE disks
cannot be used by storagesets. Do a SET <disk name> NOTRANSPORTABLE
before using this disk in a storageset
Explanation: You cannot place a TRANSPORTABLE disk into a reduced
RAIDset.
Set the disk NOTRANSPORTABLE and retry the command.
Error 3270: <disk name> not in NORMAL state. Only NORMAL state units may
be specified as a read source
Explanation: You may not specify a MIRRORset member as a read source
unless it’s in NORMAL state.
Either wait for the desired disk to enter NORMAL state or choose another
disk in the MIRRORset that’s already in NORMAL state.
Error 3280: Cannot determine if <disk name> is in the NORMAL state
Explanation: Unable to determine at this point in time if the disk specified
is in normal state.
Retry the command. If this error persists, call Digital Multivendor Customer
Services.
Error 3290: Mirrorsets are limited to 6 members maximum
Explanation: A MIRRORset may only have 6 disks as members. If you try
to exceed this amount the above message is printed.
Error 3300: Currently there are <current count> members in this mirrorset. You
must specify a membership greater than or equal to <current count>.
Explanation: YOu attempted to set the number of MIRRORset members to
less than the actual number of disk drives that make up this MIRRORset.
Either specify a number greater than or equal to the number of phsical disk
drives that make up this MIRRORset or remove one or more disk disk drives,
then reduce the member count.
Error 3310: No other switches may be specified on a MEMBERSHIP operation
Explanation: When specifying the number of members in a MIRRORset, no
other switches may be specified.
Retry the command only specifying the membership count.
Error 3320: Unable to change membership on mirrorset <mirrorset name>
Explanation: Unable to set the membership count on the specified
MIRRORset at this point in time.
Retry the command. If this error persists, call Digital Multivendor Customer
Services.
Error 3330: Can only MIRROR disks. <disk name> is not a disk
Explanation: Only disks may be MIRRORed. If you specify a device other
than a disk drive, the above error is printed.
Try the command again specifying a disk drive.
Command Line Interpreter B–135