User`s guide

ManualsBrandsDigital Equipment Corporation ManualsHome building and DecorStorage Works

481

482

483

484

485

486

487

488

489

490

Error 3340: Can only UNMIRROR disks. <disk name> is not a disk

Explanation: Only disks may be unMIRRORed. If you specify a device other

than a disk drive, the above error is printed.

Try the command again specifying a disk drive.

Error 3350 <disk name> must be conﬁgured under a mirrorset to UNMIRROR

Explanation: Only disk drives that are conﬁgured under mirrorsets may be

unMIRRORed.

Specify a disk that is conﬁgured under a MIRRORset.

Error 3360: To UNMIRROR a disk, the mirrorset must contain only one member,

the disk to be UNMIRROR. Mirrorset <mirrorset name> contains more than

one member

Explanation: To unmirror a disk drive, only one disk may be a member of

the MIRRORset.

REMOVE all disk drives but one and retry the command.

Error 3370: A MIRROR may not be done on a disk that is not conﬁgured as a

unit

Explanation: To MIRROR a disk drive either it or the storageset that it

belongs to must be conﬁgured as a unit.

Conﬁgure the disk drive or the storageset that it belongs to as a unit and

retry the command.

Error 3380: An UNMIRROR may not be done on a disk that is not conﬁgured as

a unit

Explanation: To UNMIRROR a disk drive either it or the storageset that it

belongs to must be conﬁgured as a unit.

Conﬁgure the disk drive or the storageset that it belongs to as a unit and

retry the command.

Error 3390: REDUCE of speciﬁed disks failed

Explanation: The requested REDUCE did not complete successfully.

Check the conﬁguration to assure that it was not partially completed (some

disks removed from the speciﬁed MIRRORset(s); if so, reconﬁgure and wait

for all disks to return to the NORMAL state. If this error persists, call Digital

Multivendor Customer Services.

Error 3400: <device name> is not a disk. Can only REDUCE disks

Explanation: Only disk drives may be speciﬁed on the REDUCE command.

Retry the command only specifying disks.

Error 3410: <disk name> was speciﬁed twice in the REDUCE command

Explanation: The disk drive name called out was speciﬁed twice in the

REDUCE command line.

Retry the command with only specifying disk names once.

B–136 Command Line Interpreter