User`s guide

Error 6140: Writeback cache in use on this controller but not enabled on the
other controller.
Explanation: When trying to SET FAILOVER, it was discovered that there
were write-back cache switches set on this controller but the other controller
did not have the write-back cache feature enabled.
If write-back cache is licensed on the other controller, enable it. If it is not
licensed, either contact Digital Multivendor Customer Services for licensing
information, or do not use the two controllers in dual-redundant mode, or do
not use the write-back cache switches.
Error 6150: RAID5 in use on other controller but not enabled on this controller
Explanation: When trying to SET FAILOVER, it was discovered that there
were RAID5 configurations on the other controller but this controller did not
have the RAID5 feature enabled.
If RAID5 is licensed on this controller, enable it. If it is not licensed, contact
Digital Multivendor Customer Services for licensing information or do not
use the two controllers in dual-redundant mode, or do not use a RAID5
configuration.
Error 6160: Writeback cache in use on other controller but not enabled on this
controller.
Explanation: When trying to SET FAILOVER, it was discovered that there
were write-back cache switches set on the other controller but this controller
did not have the write-back cache feature enabled.
If write-back cache is licensed on this controller, enable it. If it is not
licensed, either contact Digital Multivendor Customer Services for licensing
information or do not use the two controllers in dual-redundant mode, or do
not use the write-back cache switches.
Error 6170: An <controller type> and <controller type> cannot configured for
failover
Explanation: Two different controllers (such as an HSJ and an HSZ) cannot
be configured for failover.
Replace the other controller with the same model as this one and reissue the
command.
Error 6180: MIRRORING in use on this controller but not enabled on the other
controller
Explanation: When trying to SET FAILOVER, it was discovered that there
were MIRRORsets on this controller but the other controller did not have the
MIRROR feature enabled.
If MIRROR is licensed on the other controller, enable it. If it is not
licensed, either contact Digital Multivendor Customer Services for licensing
information, or do not use the two controllers in dual-redundant mode, or do
not use a MIRRORset configuration.
Command Line Interpreter B–143