User`s guide

Error 6190: MIRRORING in use on the other controller but not enabled on this
controller
Explanation: When trying to SET FAILOVER, it was discovered that there
were MIRRORsets on the other controller but this controller did not have the
MIRROR feature enabled.
If MIRROR is licensed on this controller, enable it. If it is not licensed,
contact Digital Multivendor Customer Services for licensing information
or do not use the two controllers in dual-redundant mode, or do not use a
MIRRORset configuration.
Error 7000: Can only clear LOST_DATA cache errors on a unit.
Explanation: you specified something other than a unit for clearing the
LOST_DATA cache error.
Error 7010: Can only clear UNWRITEABLE_DATA cache errors on a unit.
Explanation: You specified something other than a unit for clearing the
UNWRITEABLE_DATA cache error.
Error 7020: Can only retry UNWRITEABLE_DATA cache errors on a unit
Explanation: You specified something other than a unit for retrying a write
on a UNWRITEABLE_DATA cache error.
Error 7030: Unable to force write of unwriteable data
Explanation: A RETRY UNWRITEABLE_DATA command could not write
the UNWRITEABLE_DATA.
Error 7040: Unable to rundown unit before clearing error
Explanation: To clear UNWRITEABLE_DATA and LOST_DATA errors,
the unit must be rundown before the error is cleared. If the unit could
not be rundown, the above error results. If this error persists, call Digital
Multivendor Customer Services.
Error 7050: Unable to runup unit after clearing error. This controller must be
restarted
Explanation: To clear UNWRITEABLE_DATA and LOST_DATA errors, the
unit must be rundown before the error is cleared. If the unit was rundown
and the error was cleared and then the unit was unable to be run back up,
the unit will remain unavailable until the controller is restarted.
Error 7060: Cannot clear LOST_DATA on a unit without LOST_DATA
Explanation: If a unit does not have a LOST_DATA error, a CLEAR LOST_
DATA <unit number> is an illegal command.
Check to assure the unit that you wished to CLEAR LOST_DATA on does
exhibit a LOST_DATA error.
Error 7070: Cannot clear UNWRITEABLE_DATA on a unit without
UNWRITEABLE_DATA
Explanation: If a unit does not have a UNWRITEABLE_DATA error, a
CLEAR UNWRITEABLE_DATA <unit number> is an illegal command.
Check to assure the unit that you wished to CLEAR UNWRITEABLE_DATA
on does exhibit an UNWRITEABLE_DATA error.
B–144 Command Line Interpreter