User`s guide

ManualsBrandsDigital Equipment Corporation ManualsHome building and DecorStorage Works

491

492

493

494

495

496

497

498

499

500

Error 9170: <device type> <device name> at PTL <port> <target> <lun> No

device installed

Explanation: When a unit is added or initialized, the conﬁguration of the

devices that makes up the unit is checked. If no device is found at the PTL

speciﬁed, this error is displayed.

Check both the logical and physical conﬁguration of the unit and correct any

mismatches.

Error 9180: <device type> <device name> at PTL <port> <target> <lun> Incorrect

device type installed

Explanation: When a unit is added or initialized, the conﬁguration of the

devices that make up the unit is checked. If a non disk device is found at the

PTL speciﬁed, this error is displayed.

Check both the logical and physical conﬁguration of the unit and correct any

mismatches.

Error 9190: Unit <unum> is currently online

Explanation: When a SHUTDOWN, RESTART, or SELFTEST command is

entered without the OVERRIDE_ONLINE qualiﬁer and online devices are

found, the command is aborted and the units currently online are listed.

Either retry the command with OVERRIDE_ONLINE qualiﬁer or dismount

all devices from the hosts.

Error 9200: <name> conﬂicts with unit names

Explanation: This error results from an ADD command. Names in the

format of Dn and Tn, when n is a number from 0 to 4094, are reserved for

units. Rename the storageset or device that is being added so it does not

conﬂict with the unit names and retry the command.

Error 9210: Cannot check if drives are online to the other controller

Explanation: When trying to check for online drives on the other controller,

there was a communication failure.

Retry the command.

Error 9220: You cannot specify NOREAD_CACHE while in WRITEBACK_

CACHE mode

Explanation: WRITEBACK_CACHE is speciﬁed for this unit. READ_

CACHE cannot be speciﬁed while WRITEBACK_CACAHE is set.

Reissue the SET command disabling both WRITEBACK_CACHE and READ_

CACHE.

Error 9230: Unable to modify switches requested

Explanation: This error results from a SET command. The system is

currently busy.

Retry the SET command later.

Command Line Interpreter B–147