User`s guide

Error 9240: Cannot delete unit in maintenance mode
Explanation: When trying to delete a unit, the unit was found to be in
maintenance mode. This is typically the result of trying to delete a unit that
is in use by DILX or TILX.
Ensure that DILX and TILX is not being run against the unit that is to be
deleted, and retry the command.
Error 9250: Initialize of disk failed
Explanation: Unable to write metadata on disk.
Make sure the disk is not broken.
Error 9260: Cannot INITIALIZE a container that is still part of a configuration.
Delete upper configuration first
Explanation: A container cannot be initialized that is part of another
configuration or is being used by a unit.
Delete the upper configuration and reissue the INITIALIZE command.
Error 9270: Illegal command—this controller not configured for failover, but other
controller present. Stop one controller or SET FAILOVER to put both in
failover mode
Explanation: You may not change a non-dual-redundant controller’s
configuration if the other controller is running.
Stop the other controller (pop out the program card, for example) and retry
the command.
Error 9280: Cannot rename the SPARESET or FAILEDSET
Explanation: The SPARESET and FAILEDSET cannot be renamed.
Error 9290: Communication failure with other controller, cannot check other
controller’s licensing
Explanation: Unable to communicate with the other controller to check
licensing before creating a RAIDset or enabling write-back cache.
Check to make sure that both controllers are running. If one is broken, take
this controller out of failover (SET NOFAILOVER) and reissue the command.
Warning 9300: Bad write cache or battery on <controller> controller
Explanation: When trying to set failover, it was discovered that one
conrtoller’s cache had failed. For this reason the ability to place the
controller’s in a dual redundant mode has been blocked.
Repair the cache and retry the command.
Error 9310: Container metadata check failed, unit not created. <reason for
failure>
Explanation: You attempted to create a unit from a container that did not
have valid metadata.
INITIALIZE the metadata on the container, then create a unit out if it.
B–148 Command Line Interpreter