User`s guide

Warning 3000: This storageset is configured with more than one disk per port.
This causes a degradation in performance
Explanation: This warning results from an ADD storageset-type command.
The storageset specified has more than one member per port. One method
of increasing the controller’s performance is through parallel transfers to
members of a storageset. If multiple members of a storageset are on one port,
transfers must be done in serial to those members.
Though multiple storageset members on one port will work, it is strongly
recommended that the storageset be deleted and reconfigured with one
member per port.
Warning 3020: <storageset name> is configured with different sized containers.
This will result in a storageset of reduced size
Explanation: This warning results from an ADD storageset-type command.
Storageset size is determined by the size of the smallest device, so the
storageset configured will be of reduced size.
If a reduced size storageset is acceptable, nothing needs to be done in
response to the above warning. To realize the maximum storageset size, the
size of all devices that make up the storageset should be identical.
Warning 3030: Cannot determine state of disk <disk name>in mirrorset
<mirrorset name>
Explanation: Before disk drives are removed from a MIRRORset, the
MIRRORset is checked to assure that at least one NORMAL member will
be left after the REMOVE or REDUCE. If the state of a disk cannot be
determined, the above message is printed.
Warning 3040: <storageset name> will be disabled due to bad cache state on
<controller> controller
Explanation: If the cache is in a state on this or the other controller such
that the storageset cannot be used, it will be created but the above message
will be printed so the user knows that the storageset wil be disabled.
Warning 4000: A restart of this controller is required before all the parameters
modified will take effect
Explanation: This warning results from a SET THIS_CONTROLLER
command. Some controller parameters require a restart before they can take
effect. If any of those parameters are changed, this warning is displayed.
It is recommended that a restart via the ‘‘RESTART THIS_CONTROLLER’’
command be done as soon as possible.
Warning 4010: A restart of the other controller is required before all the
parameters modified will take effect
Explanation: This warning results from a SET OTHER_CONTROLLER
command. Some controller parameters require a restart before they can take
effect. If any of those parameters are changed, this warning is displayed.
Restart the controller and retry the command.
Command Line Interpreter B–151