User`s guide

Warning 9090: Metadata found on container. Are you sure this is a
TRANSPORTABLE container?
Explanation: When a transportable disk was initialized, metadata was
found.
Verify that this disk in fact should be marked transportable. No action is
required to correct this warning.
Warning 9100: Bad or low battery or bad write cache on <controller> writeback
cache will not be used
Explanation: The battery is low or bad on the specified controller. The
unit specified will not use write-back cache until the battery is charged or
repaired.
Warning 9110: Bad or low battery or bad write cache on <controller> this unit
cannot be used by <controller>
Explanation: The battery is low or bad on the specified controller. The unit
specified requires the use of write-back cache, so its use has been disabled
until the battery is charged or repaired.
B.3 Device Configuration Examples
The following examples cover the majority of configurations and the method of
defining those configurations.
Example B–1 Initial Single Controller Configuration of an HSD30 Controller
CLI> SET THIS_CONTROLLER ID=5 SCS_NODENAME="HSD03"
CLI> SET THIS_CONTROLLER MSCP_ALLOCATION_CLASS=4 TMSCP_ALLOCATION_CLASS=4
CLI> RESTART THIS_CONTROLLER
[this controller restarts at this point]
CLI> SET THIS_CONTROLLER PATH
Example B–2 Initial Dual-Redundant Controller Configuration of an HSJ
Controller
CLI> SET THIS_CONTROLLER MAX_NODES=16
CLI> SET THIS_CONTROLLER ID=5 SCS_NODENAME="HSJ01"
CLI> SET THIS_CONTROLLER MSCP_ALLOCATION_CLASS=4 TMSCP_ALLOCATION_CLASS=4
CLI> SET FAILOVER COPY=THIS
CLI> SET OTHER_CONTROLLER MAX_NODES=16
CLI> SET OTHER_CONTROLLER ID=7 SCS_NODENAME="HSJ02"
CLI> RESTART OTHER_CONTROLLER
[other controller restarts at this point]
CLI> RESTART THIS_CONTROLLER
[this controller restarts at this point]
CLI> SET THIS_CONTROLLER PATH_A PATH_B
CLI> SET OTHER_CONTROLLER PATH_A PATH_B
B–154 Command Line Interpreter