User`s guide

HS array controller (cont’d)
executive functions, 2–13
features of, 1–12
firmware overview, 2–12
hardware functional overview, 2–1
initialized by, 5–1
interface host port, 2–3
OpenVMS AUTOGEN.COM change, 8–5
overview, 1–1
personnel needed, 4–3
policy processor, 2–2
read cache module option, 1–15
SCSI–2 device ports, 2–3
self-test and diagnostics, 2–13
shared memory, 2–2
site preparation, 4–1
subsystem installation, 4–10
subsystem power, 4–2
tools for installation, 4–3
warm swap, 5–30
write-back cache module option, 1–15
HSD30 array controller
controllers per DSSI bus, 1–5
description of, 1–4
DSSI bus rules, 1–6
host port cable lengths, 4–8
installing host port cables, 4–16
mating guide for host port connector, 4–7
module specifications, 1–14
OCP, 2–7
separate buses, 1–6
separate host buses, 3–13
turning on host paths, 4–23
HSJ array controller
dual data link, 1–12
installing host port cables
nonredundant
dual-redundant, 4–15
module specifications, 1–14
OCP, 2–7
setting quiet slot time, 4–15
subsystem hardware block diagram, 1–4
HSJ30 array controller
description of, 1–2
HSJ40 array controller
description of, 1–2
preconfigured subsystems, A–4
HSOF, 2–12
HSZ40 array controller
configuring units, 8–30
description of, 1–6
HSZterm, 2–14
installing host port cables
nonredundant
dual-redundant, 4–17
module specifications, 1–15
OCP, 2–8
SCSI target IDs, 1–19
HSZ40 array controller (cont’d)
setting SCSI ID, 5–11
terminator, 1–7
trilink connector block, 1–7
with DWZZA host adapters, 1–7
HSZ40–Bx array controller
terminal phone cable
terminal coupler, 2–10
terminal port, 2–11
HSZterm utility, 7–59
for HSZ virtual terminal connection, 1–13
virtual terminal connection, 2–14
I
ID
setting of, 5–7
I/D cache, 2–2
IDs
of controller slots, 1–18
Initial reconstruct, 6–5
Initialization
cache module, 5–4
CFMENU utility, 7–66
controller, 7–1
controller subsystem, 5–3
diagnostics, 5–3
dual-redundant configuration, 5–3
of array controllers, 5–1
of containers, 5–10
time to complete, 5–1
with bad cache, 2–13
with bad ports, 2–13
Initialization state
visual, 5–18
INITIALIZE command, 5–10, B–39
Installation
dual-redundant controller, 4–24
HSD30 host port cables
trilink connector block
terminators, 4–22
of HSJ (CI) host port cables, 4–21
preconfigured subsystems
CTO subsystems, 4–10
for CTO subsystems, 4–14
program card, 4–27
read cache
write-back cache, 5–43
K
Key, licensed features, 7–54
KILL signal
function of, 2–20
Index–7