User`s guide

O
OCP
description of, 2–6, 5–18
disk drive configuration mismatch
disk drive failure, 5–23
for HSD30 array controller, 2–7
for HSJ array controllers, 2–7
for HSZ array controllers, 2–8
how it functions, 5–18
LED code normal state, 5–24
LED error codes, 5–20
Led error codes, clearing, 5–24
use of buttons, 5–18
use of LEDs, 5–18
OpenVMS
preferred path utility, 8–6
SHOW DEVICE, 8–6
OpenVMS Alpha
DECevent, 8–13
ERF support, 8–9
loading the FYDRIVER, 8–16
OpenVMS VAX
AUTOGEN.COM change, 8–5
changing timeout value, 8–8
DECevent, 8–13
device size limitation, 8–3
ERF support, 8–9
maximum byte count for ERASE, 8–4
shadow set members, 8–8
using CLUSTER_SIZE qualifier, 8–7
Operating system support, 8–1
device capacity, 8–3
fully supported, 8–1
limitations
SHOW DEVICE, 8–6
minimum versions, 8–2
OpenVMS Alpha, 8–16
OpenVMS VAX, 8–3
support with limitations, 8–1
Operating system support limitations
cluster size, 8–7
DCL BACKUP/IMAGE, 8–7
DCL INITIALIZE, 8–7
shadow set members, 8–8
Operator control panel
HSD30 array controller, 2–7
HSJ array controllers, 2–7
HSZ array controller, 2–8
See also OCP, 2–6
OTHER_CONTROLLER
defined, 2–16
Overview
HS array controllers, 1–1
P
Parameters
setting, 5–6
Passthrough containers, 7–101
CFMENU utility, 7–65
Paths (host port)
how to disable, 5–8
how to enable, 5–8
PCMCIA card
See program card., 2–9
Performance
for highest, 3–14
setting optimal configurations, 3–14
Physical description
of HSD30 array controller, 1–4
of HSJ30
of HSJ40, 1–2
of HSZ40 array controller, 1–6
Port buttons
numbering, 5–18
Port Target LUN
See PTL
Power cords
country specific, 4–2
Power supply
failure, 5–30
location of, 1–18
status LEDs, 5–24
Powering off your system
rules for, 5–43
Preconfigured subsystems, A–4
installation, 4–10
Preferred paths
setting for HSJ
setting for HSD30, 5–13
setting for HSZ, 5–14
Program card
description of, 2–9
ECC, 5–2
ESD protection, 4–6
ESD shield
precautions, 2–10
handling guidelines, 4–5
insertion
removal, 4–27
upgrade of dual-redundant configuration, 4–29
upgrade of nonredundant configuration, 4–28
Prompt
setting the CLI prompt, 5–5
Protocols
CI
DSSI
SCSI, 2–13
controller host interface, 1–7
host interconnect, 2–13
MSCP
Index–9