User`s guide

REPLACE=disk-device-name, B–62
Replacement
read cache
write-back cache, 5–43
Replacing a device
warm swap, 5–29
Reset (//) button, 5–18
controller failure, 2–6
controller initialization, 2–19
controller restarts, 2–6
Reset state
recovering from, 2–10
RESTART OTHER_CONTROLLER command,
2–19, B–48
RESTART THIS_CONTROLLER command, B–50
Restrictions
CFMENU utility, 7–60
FLS, 7–54
RETRY_ERRORS UNWRITEABLE_DATA
command, B–53
Rules
for system power off, 5–43
RUN command, B–54
S
SBB shelf, 1–18
SBB shelf device
3½-inch
5¼-inch, 1–17
numbering
addresses, 1–18
rules for moving, 5–45
warm swap, 5–27
SCS node name
setting of, 5–7
SCSI bus
lengths, 4–9
termination, 4–24
SCSI host cable, 3–24
length, 3–24
SCSI hosts
and storage, 1–11
SCSI ID slots
in BA350–MA controller shelf, 3–13
when adding a second controller, 4–25
SCSI protocol
to devices, 1–19
to hosts, 1–19
SCSI target IDs
configurations, 2–20
default, 5–11
dual-redundant configuration, 2–16
setting of, 5–7, 5–11
SCSI–2 address
of devices, 1–18
SCSI–2 address of devices
determined by, 1–18
SCSI–2 device cables
guidelines, 4–9
SCSI–2 device ports, 2–3
SCSI–2 trilink connector block
for HSZ40 array controllers, 1–7
Self-test and diagnostics
of controller, 2–13
SELFTEST OTHER_CONTROLLER command,
B–55
SELFTEST THIS_CONTROLLER command,
B–57
SET disk-container-name command, B–59
SET FAILOVER command, 5–12, B–60
SET mirrorset-container-name command, B–62
SET NOFAILOVER command, 2–18, B–65
when to use, 2–18
SET OTHER_CONTROLLER command, B–66
SET RAIDset
REMOVE= qualifier, 6–15
REPLACE= qualifier, 6–15
SET RAIDset-container-name command, B–73
SET THIS_CONTROLLER command, B–75
SET unit-number command, B–82
Shadow sets (host-based)
mixing drives, 8–8
physical size, 8–8
timeout value, 8–8
Shared memory
on controller module, 2–2
Shelf
configurations, 3–10
Shelf power
configuration rules, 4–2
SHOW cdrom-container-name command, B–93
SHOW CDROMS command, B–92
SHOW DEVICES command, B–94
SHOW disk-container-name command, B–96
SHOW DISKS command, B–95
SHOW FAILEDSET command, B–97
SHOW loader-container-name command, B–99
SHOW LOADERS command, B–98
SHOW mirrorset-container-name command,
B–102
SHOW MIRRORSETS command, B–100
SHOW optical-container-name command, B–104
SHOW OPTICALS command, B–103
SHOW OTHER_CONTROLLER command, B–105
SHOW PASSTHROUGH command, B–107
SHOW passthrough-container-name command,
B–108
SHOW raidset-container-name command, B–111
SHOW RAIDSETS command, B–109
SHOW SPARESET command, B–112
SHOW STORAGESETS command, B–113
Index–11