User`s guide

SHOW stripeset-container-name command, B–117
SHOW STRIPESETS command, B–115
SHOW tape-container-name command, B–119
SHOW TAPES command, B–118
SHOW THIS_CONTROLLER command, B–120
determining the cache module type, 4–31
SHOW unit-number command, B–124
SHOW UNITS command, B–123
SHUTDOWN
controller, 5–43
use of, 5–45
SHUTDOWN OTHER_CONTROLLER command,
5–43, B–125
SHUTDOWN THIS_CONTROLLER command,
5–43, B–127
Site preparation, 4–1
Slot numbers
for controllers, 1–18
for SBBs, 1–18
Sparesets
adding members
deleting members, 6–13
CFMENU utility, 7–64
defined, 6–6, B–13
Specifications
cache modules, 1–14
controller modules, 1–14
environmental, 4–2
HSD30 array controller module, 1–14
HSZ40 array controller module, 1–15
Star coupler
attaching CI cables, 4–21
CI cable length to, 4–7
Status LEDs
battery backup unit, 5–24
power supply, 5–24
Storage addressing
controller perspective, 1–8
controller PTL, 1–10
differences in HSZ40 array controllers, 1–12
host perspective, 1–10
host perspective, HSZ40 array controllers, 1–11
host PTL, HSZ40 array controllers, 1–12
Storage shelf
SW300-series cabinet shelf, 3–11
Storagesets
CFMENU utility, 7–62, 7–63, 7–64
defined, B–113
maximum number of, 6–8
SHOW command, 6–13
StorageWorks products, 1–16
Striped mirrorsets
device limit, 6–8
Stripesets
add
initialize, 6–17
CFMENU utility, 7–62
defined, 6–6
Stripesets (cont’d)
maximum chunksize, 6–6
mirrored, 6–2
SHOW command, 6–12
showing, 6–17
when batteries fail, 6–7
SW300-series cabinet
configuration rules, 3–8
SW300-series cabinet shelf
configuration, 3–22, 3–23
configuration rules, 3–11
SW300 configuration rules, 3–8
SW500 configuration, 3–7
SW500-series cabinet, 1–17
capacity, 4–11
configuration rules, 3–6, 4–13
SW800-series cabinet
configuration rules, 3–2
SW800-series data center cabinet, 1–17
capacity, 4–12
configuration rules, 4–13
SWAP_L interrupt signal, 5–30
System management
of HS array controllers, 8–2
T
Tagged command queuing, 1–19
Tape drives
warm swap, 5–30
Target IDs
HSZ40 array controller, 1–11
Target IDs, SCSI
setting of, 5–11
Terminal port, 2–10
Terminal setup
CFMENU utility, 7–68
Termination
of SCSI bus, 4–24
Terminator
for HSD30 array controllers, 1–5
for HSZ40 array controllers, 1–7
installation for HSD30, 4–22
part number for HSD30, 4–22
part number for HSZ, 4–23
THIS_CONTROLLER
defined, 2–16
TILX
defined, 7–17
example, using all defaults, 7–20
example, using all functions, 7–19
interrupting, 7–18
invoking form maintenance w/VCS, 7–17
invoking from a maintenance terminal, 7–17
invoking from virtual terminal, 7–17
TMSCP allocation class
setting of, 5–7, 5–12
Index–12