User`s guide

Table 4–1 (Cont.) StorageWorks Environmental Specifications
Condition Specification
Maximum Nonoperating Environment (Range)
Temperature –40° to +66°C (–40° to +151°F)
(During transportation and associated short–term storage)
Relative humidity
Nonoperating 8% to 95% in original shipping container (noncondensing);
otherwise, 50% (noncondensing)
Altitude From –300 m (–1000 ft) to +3600 m (+12,000 ft) MS
4.2 Before You Begin
Before you begin installing your HS array controller subsystem, consider the
following items:
• How many people are needed for unpacking and installation?
• What type of tools are needed for unpacking and installation?
• What ESD protection is required? (See Section 4.2.3.)
The following sections discuss these items.
4.2.1 Personnel Needed for Installation
The number of people needed to install an HS array controller subsystem depends
on the size and weight of your subsystem cabinet. Most add-on options require
only one person.
A fully-loaded SW800-series or SW500-series cabinet can require two to three
people to remove it from the shipping pallet because of the cabinet’s weight. For
details, refer to the StorageWorks SW800-Series Data Center Cabinet Installation
Guide, the StorageWorks SW500-Series Cabinet Installation and User’s Guide,or
the StorageWorks Solutions SW300-Series RAID Enclosure Installation and User’s
Guide.
4.2.2 Tools Needed for Installation
The following tools may be needed during the installation of your controller
subsystem. Not all of the tools listed are required for every cabinet type.
• Wrench to lower and tighten the four cabinet leveler feet.
• Allen wrench (5/32-inch) to open the cabinet front door (SW800-series data
center cabinets)
• Allen wrench (3/32-inch) to loosen the four screws that hold the front OCP
bezel in place
• Straight-edge screwdriver to install host port cables.
• Very small straight-edge screwdriver to remove trilink connector blocks on
HSD30 and HSZ front bezels.
• ESD wrist strap for handling the controller or cache modules (if applicable).
The part number for the Portable Anti-Static Kit is 29–26246–00.
• A pointed object for pushing the port buttons on HSD30 and HSZ array
controller operator control panels.
Installation 4–3