Technical data

Removing Fixed Disk Drives
Remove RZ2x
Disk Drives
Remove all the supported RZ2x disk drives from the drive plate.
Two of these drives can be installed into the VAXstation 4000
system unit.
To remove an RZ2x disk drive from the model 30 or 38, do the
following and refer to Figure 2–2:
1. Disconnect the SCSI and power cable from the disk drive.
2. Push down the drive plate lever and slide the RZ2x disk
drive over the lever until the fixed disk drive comes up and
out of the keyholes on the plate.
3. Remove the mounting plate from the drive. The RZ2x
drives have a different mounting plate when installed in the
VAXstation 4000 system unit.
Model 30 Only:
Remove the drive plate first to access the screws that
hold the drive to the drive plate. (See Figure 2–5.)
Removing Options from a Model 30 and 38 Workstation 2–3