Technical data

Removing Fixed Disk Drives
Figure 3–3 Removing the Upper Drive Plate from the Model 40 and 48 System
MLO-006507
Captive
Screws (2)
Captive
Screws (2)
Upper Drive Plate
Captive Screw
Remove RZ2x
Disk Drives
Remove the supported RZ2x disk drives from the upper drive
plate. Two of these drives can be installed into the VAXstation
4000 system unit.
To remove the RZ2x disk drives from the upper drive plate, do
the following and refer to Figure 3–4:
1. Turn the Model 40 or 48 upper drive plate over so the RZ2x
drives are facedown.
2. Using a Phillips-head screwdriver, unscrew the four screws
that hold each drive to the drive plate. Support each drive
with one hand when removing the last screw.
3. Set the drives aside for installation in the VAXstation 4000
system later.
3–6 Removing Options from a Model 40 and 48 Workstation