Technical data

Removing the Ethernet ROM

Figure 3–6 Removing the Lower Drive Plate

MLO-006510

Captive

Screws (2)

Captive

Screws (2)

Lower Drive Plate

Slide Mount

Screws (3)

Slide Mount Openings (3)

Note

Depending on the system conﬁguration, the Model 40 or

48 system can have two types of coprocessor modules: the

graphics coprocessor module or the scanline coprocessor

module. These two modules are similar except for a

couple features. To remove the scanline coprocessor, you

must remove three screws from the mounting brackets,

then release the tabs from the post locks. The graphics

coprocessor module has only four post locks with tabs

holding it to the system board.

3–10 Removing Options from a Model 40 and 48 Workstation